WSER UNIVERSAL CHEAT SHEET
Please refer to full programming instructions for further information.
Assign first remote – Apply power OR press and release the RED button on motor (WHITE button on DC battery motor). Motor jiggles (you have 10 seconds to assign the first remote).
| FUNCTION | PRESS UP & DOWN TOGETHER FOR 1sec | THEN PRESS STOP BUTTON | THEN PRESS BUTTON BELOW | NOTES |
|---|---|---|---|---|
| assign 1st remote (see above) |  | 1x | ||
| enter step by step mode | | 1x | press UP | |
| exit step by step mode | | 1x | press DOWN | |
| set top limit | | 2x | press UP | |
| set lower limit | | 2x | press DOWN | |
| turn obstacle detection function ON | | 3x | press UP | this feature is only available on obstacle detection motors |
| turn obstacle detection function OFF | | 3x | press DOWN | this feature is only available on obstacle detection motors |
| delete upper limit | | 4x | press UP | on Cassette Awning motor you need to only delete bottom limit, which deletes both top and bottom limits |
| delete lower limit | | 4x | press DOWN | on Cassette Awning motor this function will delete ALL limits |
| delete ALL remotes, motion sensors and wind sensors from a motor | | 6x | press UP | all motors listening to this channel will delete all linked remotes, motion sensors and wind sensors from the motor (USE THIS FUNCTION WITH CAUTION) |
| change motor direction | | 6x | press DOWN | OR press and hold RED button for 3 seconds, motor jiggles to confirm |
| delete a channel from a motor | | 7x | press UP | if the motor which responds to the channel selected has other channels from this remote, they will all be deleted (USE THIS FUNCTION WITH CAUTION) |
| copy a remote channel from existing remote to a new remote | | 8x | motor jiggles | after motor jiggles, take new remote and press UP and DOWN together, then press STOP |
| set 3rd limit/favorite | move blind to required position and press STOP 4 times |
| move blind to 3rd limit | hold STOP button for 2 seconds |
PLEASE NOTE
No hard reset is possible using Alpha remotes or motors.
If a 240v motor will not allow you to assign a remote:
1. Disconnect power from motor. Reconnect power, motor jiggles, wait 5 seconds and then disconnect power again.
2. Reconnect and disconnect power as per above 3 times making sure motor jiggles each time you reconnect power,
wait 5sec before disconnecting and reconnecting power. After the third time you reconnect power and the motor jiggles, assign remote as normal.